08 Toyota Tundra Code C1241

Found broken wires in the harness.

08 toyota tundra code c1241. The cost to diagnose the C1201 TOYOTA code is 10 hour of labor. I started hearing a ticking noise only when accelerating and shortly after the check engine light came on. The techstream says High or Low Power Voltage.

If your 2007-2008 Toyota Tundra experiences a No Start condition with a check engine MIL light on and codes B2799 andor B2780 B2784 B2796 B2797 B279A you will want to check out TSBs 0078-09 and 0220-08. A Turn the ignition switch off. - Stop light switch circuit.

I would have that checked first. When C124141 andor C124242 is output together with C120258 inspect and repair the trouble areas indicated by C124141 andor C124242 first. The C0200 C0205 codes were phantoms.

When there is an abnormality in the power supply circuit of the brake actuator skid control ECU the skid control ECU sets a DTC and the operation is prohibited by the fail-safe function. In order for the stability control system to work properly it must know what the yaw and deceleration sensors report when the vehicle is stopped on a level surface. DTC C120258 Brake Fluid Level Low Open Circuit in Brake Fluid Level Warning Switch Circuit DTC No.

C0210 Right wheel speed sensor signal malfunction. Car RCA DC Audio Video AV Extension Cable for CCTV Security Truck Bus Trailer Reverse Parking Camera 5 Meters16 Feet - 2 in 1 RCA Video DC Power Cable. C1241 Toyota hybrid 2009.

The auto repairs diagnosis time and labor rates vary by location vehicles make and model and even your engine type. Some customers may experience a crank and No start condition accompanied by immobilizer DTC B2799 andor B2780 B2784 B2796 B2797 B279A. If there is a problem with the brake actuator assembly Skid Control Electronic Control Unit power supply circuit the skid control ECU outputs the Diagnostic Trouble Code DTC and prohibits under the fail safe function.