08 Toyota Tundra Reset Maintenance Light

So this is to share the solution.

08 toyota tundra reset maintenance light. Hold ODOTRIP BUTTON For At Least 5 Seconds Until RESETTING MAINTENANCE DATA is complete. The vehicle was not repaired. Finally I resolved it with the official Toyota Owners Manual in 2 minutes.

Once you can see the reading on the Trip Metre A switch off the ignition. Press and hold trip meter reset knob and turn the ignition to the RUN position. I hope the following helps.

That it is the full procedure how to reset ABS warning light Toyota Tundra 2 generation. The Trip Reset button is located at the bottom right of the speedometer window in the dashboard. Standard Grille Badge Fit for Toyota Tacoma 4Runner Tundra Tri-color Grille Badge White Light blue Dark blue.

The flashing dashboard light will go off and the reading on the odometer will reset. Wait for the system to reset. If you like to reset any maintenance oil light after an oil change.

That it is the full procedure how to reset VSC OFF warning light Toyota Tundra 2 generation. Or any warning light for service reminder which appears on the display. How to Reset the Change Oil Light on a 2008 Toyota Tundra Set the odometer display on the dash to Trip A by pushing the Trip Reset button once.

The contact stated that the check engine warning light illuminated intermittently. Press And Hold ODOTRIP BUTTON And Turn Ignition To RUN Position. Turn the ignition to the RUN position.