08 Toyota Tundra Shift Solenoid C Control Circuit High

They want to replace the transmission wire harness and engine harness due to corroision and a broken pin 230000USD 1300 parts 10 hours labor.

08 toyota tundra shift solenoid c control circuit high. P0974 is a diagnostic trouble code DTC for Shift Solenoid A Control Circuit High. The replacement cost of a shift solenoid replacement depends a. P0983 ACURA Shift Solenoid Valve D Open.

Shift Solenoid D Control Circuit High. If one of these checks fails such as encountering an open circuit on Shift Solenoid B SSF the TCM disables that control circuit and sets DTC P0977 Shift Solenoid B Control Circuit High in ECM memory. P0974 TOYOTA code description The Engine Control Module commands gear shifts by turning the shift solenoid valves ONOFF When there is an open or short circuit in any shift solenoid valve circuit the ECM detects the problem and illuminates the engine light and stores the Diagnostic Trouble Code DTC.

When there is an open or short circuit in any shift solenoid valve circuit the ECM detects the problem and illuminates the engine light and stores the Diagnostic Trouble Code DTC and the ECM performs the fail-safe function and turns the other shift solenoids valves in good condition ONOFF. Toyota Tundra Forum. It was a P0974 code shift solenoid A control circuit high.

Also found this helpful link. I took it to the shop. P0977 Shift Solenoid B Control Circuit High P0985 Shift Solenoid E Control Circuit Low.

082014 - Title. Just got back from dealer. Shift solenoid valve C is turned ON or OFF by the Transmission Control Module TCM in response to signals sent from the parkneutral position PNP switch vehicle speed and Engine Control Module ECM throttle opening.

Shift Solenoid D Control Circuit Low Shift Solenoid Valve S4 Comes on. On highway speeds at 60mph and above it is sitting at 3500RPM. P0983 DODGE Shift Solenoid D Control Circuit High.