2000 Toyota Tundra How To Get Off The Drum Cover

1 Open the Tundras hood and locate the back of the headlight assembly inside the engine compartment.

2000 toyota tundra how to get off the drum cover. About a week later the Right was found to be dragging and I had to bang the drum off and back off the adjuster. Bolt size is M8x125. It boasts a reasonable size good.

I pull mine off every 20000 miles to inspect and blow out the brake dust. Still no luck beat it around the edges with a heavy rubber mallet. I havent tried adjusting it but Ive been pulling the wheels and taking a look at the pads to see where I am.

Or its just a very tight fit. If no luck back off the adjuster and try again. This must be cut off to get the old bearing and seal off.

Step 3 Use an angle grinder to clean up the mating surface where the new cover will be installed. Once its loose enough you should be able to rock the drum back and forth to pull it off. The center hub doesnt even appear to be separate from the drum.

Carefully dispose of the bulb to prevent it from cracking or shattering. Locate the two holes on the drum as shown in Figure 1 and screw in two metric bolts. The bearing is held in place on the axle by a keeper collar.

2000 Toyota TUNDRA TSBs Technical Service Bulletins. Make sure the ebrake is off and pull. I turned down the adjuster but it makes no difference.