2000 Toyota Tundra Rear Axle Removal

There are 4 bolts for each rear axle.

2000 toyota tundra rear axle removal. I got a 2000 Toyota Tundra 47 Auto. Forums Tundra Discussion 1st Gen Tundras 2000-2006. I have replaced the rear axle bearing twice both on the passenger side.

Discussion Starter 1 Dec 20 2011 Edited Took my 08 Tundra 2wd to a local shop that specializes in trucks so they can replace the rear axle bearing. 10 mm wrench Third remove the drain and fill plugs from the axle and let the fluid drain out into a container for proper disposal. I pulled the rear axles out today to be sent off and have new bearings pressed in and replace the tube seals.

Nitro Gear Axle take the steps necessary to. Hello everyone Im the proud owner of an 03 Tacoma 4x4. Im installing a rear axle bearing oil seals on my 1985 Toyota Pickup 4x4 without using a press.

I have a 2002 tundra 47 l engine 2 wheel drive. Also you should replace the seals for the axles of if you are changing the bearings. Remove the 10mm bolt holding the parking brake cable to the rear of the hub assembly and pull the cable assembly out the back.

Next remove the 4 17mm nuts that hold the axle and bearing assembly to the axle tube. 2000 Tundra Limited 4x4 1100 Build 32 lift visor 2857516 eibach pro-truck Cvj axles custom lighting. First remove the 4 bolts from the driveshaft and lift it up and secure it with the bungee cord.

This will expose the parking brake cable end shown below. Common causes of axle seal failure are plugged differential breathers or worn wheel bearings. You will loosen the lug bolts raise and support the truck remove the wheel then remove the brake drum then remove the 4 bolts that hold the backing plate onto the rear axle tube remove the brake line from the wheel cylinder disconnect the e-brake cable and then pull the axle out.