2000 Toyota Tundra Rear Bumper Removal

Unplug the connector on the back side of the license plate lights.

2000 toyota tundra rear bumper removal. Bumper end cover removal. Remove screws 29 and license plate 30. Toyota Tundra Rear Bumper Removal.

Remove tail lamp four 8mm nut perside unplug wires. -With an assistant we release the corners from the latches in the wings and remove the bumper from the guides on ourselves. Remove your license plate.

After those bolts are removed you can pull the sides of the cover away from the quarter. I am assuming you have the 5VZ-FE engine which can pull 4900 lbs SR5 or 4750 lbs Limited. There are a bunch of tabs that you have to pinch inorder to remove the big black plastic piece that runs the width of the bumper.

-remove the cover of the bumper underneath and Unscrew two screws on each side twisted upside down-around the bottom part Unscrew the screws spun up-assistant exempt corners of the latches in the wings and remove the bumper from the guides themselves-remove the connector from the fog lamp if any-remove connector from the PDC if any. 2000 Toyota Tundra 1099. I am going to paint mine this weekend.

Discussion Starter 1 May 16 2010. Do the two outer parts first. B Remove the towing eye covers on the lower section of the bumper and you will find one 13mm nut in each.

Toyota Tacoma 05-15 Tundra 00-06 Rear Bumper Dome Caps set of 2 Genuine Fits. All the same-as-original bumpers from Replace are a perfect option to go if you want to restore and maintain the original look of your vehicle. Then turn it over and undo about a zillion clips with needle nose pliers to take the three top plastic pieces off.