2000 Toyota Tundra Throttle Position Sensor Adjustment
The TPS is on the drivers side and the APS is on the pass side of the throttle body.
2000 toyota tundra throttle position sensor adjustment. Made mistake of removing the throttle lever sensor. Replaced TPS and now cannot get it to run right. Land Cruiser Sequoia Tundra 47L V8.
Please also check out the statistics and reliability analysis of the 2000 Toyota Tundra based on all problems reported for the 2000 Tundra. APPS accelerator pedal position sensor. At wide open throttle signal voltage is approximately 35 - 47 volts.
Mechanicjon Oct 24 2019 2. Radiator Support For 97-2000 Toyota. After shifting into drive or reverse the rpms drop instantly too 700 or so.
Your TPS does need to be adjusted loosen both set screws on the sensor and apply vacuum to the thottle opener dash pod. It is located between the engines intake manifold and the air filter. 03 have no adjustment from what I understand.
When it runs I can push the accelerator half way down and nothing. Then it will accelerate but nothing during 1st half of pedal. Turn the key to the ON position but do not start.
Push gas pedal slowly and steadily to the floor 3x. I found out once I removed those that assembly that this truck doesnt have an IAC valve it has a Throttle Position Sensor and a. Inside the TPS is a resistor and a wiper arm.