2001 Toyota Tundra Ignition Switch Removal

The two primary components in a Toyota trucks ignition system are the actual ignition switch and the lock cylinder which work with the ignition key.

2001 toyota tundra ignition switch removal. Secure the switch with its screws. Detach the illumination ring by pulling out the plastic pin on the side. May apply to differnt Toyota vehicles as well2010 Toyota Tundra SR5.

The key will turn only enough to unlock the steering wheel and put the truck in gear. Remove the lower steering column cover. To remove the ignition switch unfasten its securing screws and withdraw the switch from the lock housing.

Align the locking cam with the hole in the ignition switch and insert the switch into the lock housing. Press the release bottom with this screwdriver as you pull the lock cylinder straight out. ---- Automotive Locksmith Services in Atlanta GA Metro Area.

REMOVAL AND INSTALLATION Ignition Switch Removal. Slide the cylinder into the lock housing until the stop tab engages the hole in the lock. Remove unlock warning switch cable transponder key amplifier and then unlock warning switch.

2006 toyota tundra the ignition switch is sticking and at present is stuck thus not allowing the truck to start. Switch out of the lock position into starting my truck. I am having intermitted.

Replacing them can be tricky. Discussion Starter 1 Jul 2 2005. T he ignition on my 2002 Toyota Tacoma 4x4 TRD locked up after I parked with the left front wheel pushed against a curb vehicle at 40 degree angle to the curb.