2004 Toyota Tundra Brake Bleeding Sequence

If youre keen on trying to replace the brake fluid.

2004 toyota tundra brake bleeding sequence. My auto shop teacher says. Bleeding the ABS system usually requires the toyota Techstream tool to activate the ABS actuator which is not a part of the vehicles primary braking system. As on any vehicle start with the Wheel furthest from the master cylinder and work your way to the closest.

BLEED BRAKE LINE. After bleeding the brakes driving less than 100 miles the brakle padal. So it should be left front right front left rear right rear.

6 Nov 2 2009. My understanding is to bleed a line then operate Techstream to actuate the ABS for that line then repeat the process for the remaining three lines. The process is 4 pages long in the service manual.

Httpsamznto2MOkKtnRear speed bleeder valve. You should start with the wheel closest to the master cylinder and work you way to the wheel furthest away. A Front brake line.

You could also suck as much fluid out of the master cylinder as possible refill with fresh brake fluid from an unopened container open all 4 bleeders and gravity bleed the system with a pan under each wheel. Ad Find Instant Quality Info Now. You have to start at the proper wheel and pump up the system with the foot brake at least 20 times before you can even use the tech stream to work the ABS.

Access our Toyota 4Runner 2001-06 Bleeding the ABS System Repair Guide by creating an account or signing into your AutoZone Rewards account. 3 Depress the brake pedal several times then. I bled my brakes and now the pedal goes to the floor all the time with little stopping power.