2008 Toyota Tundra Brake Controller Installation

I had originally mounted mine like Tox the decided to move it so.

2008 toyota tundra brake controller installation. Question is what wires go to what on the brake controller. Toyota Tundra photo by Toyota Since the 2016 model year every Tundra equipped with the 57 Liter i-Force V8 engine has also included an integrated trailer brake controller system standard. The 12 volt wire in the 7 Pin connector that goes to your trailer battery only.

Electric Trailer Brake Controller - REESE Brand installation cheaper link. I have a Hidden Hitch electronic brake controller I want to install in my Tundra. The answer to your question about fuses and relays is YES everything is there ready to go once you connect your controller.

Genuine Toyota Trailer Brake Controller 89547-0C011 with Dash Bezel 55447-0C020-C0. This guide will go over the Trailer Braking System equipped on the Toyota Tundra Full-Size Pickup Truck. Ok so I have a 2008 Tundra that came with the factory brake controller harness in the glove box.

See below2014 Toyota Tundra equipped with Tow PackageChannel merchandise and. Discussion Starter 1 Nov 10 2012. It works for 1 up to 4 axles.

Installation instructions for 2007-2013 Toyota Tundra without the use of a piggyback harness. Hard wire your brake controller with your factory controller ha. Call 800-298-1624 to get Expert Service ordering a Brake Controller for your 2008 Toyota Tundra.

7-way trailer connector mounting bracket and hardware black loom gray duplex cable that runs from the trailer connector to the front of the vehicle circuit breakers wire connectors scotch locks and. I tow a 4700 travel trailer the brake controller works like wonders in the mountains. Equal-i-zer 4-point Sway Control Hitch 90-00-0600 6000 Lbs Trailer Weight Rating 600 Lbs Tongue Weight Rating Weight Distribution Kit Includes Standard Hitch Shank Ball NOT Included.